Feature Requests

Library search box gets cleared when you switch from Library to Objects tab.

They snap but they are not connected to wires (red rings don't disappear).

If I select a certain wire elbow direction, I can get a wire segment which will not slide and appears to always be aligning to an adjacent pin alignment guide. This loom recording shows it all: https://www.loom.com/share/4f77b32672654bd49e6c22c8d0ff9f7d

Net connection points on the schematic have inconsistent behavior. There should always be a dot when two nets on top of each other are connected. Contrarily, if two nets on top of each other are not connected, there should never be a dot.

Enable spacing of pins on parts and wires to some standard spacing where possible, or allow alignment in wires so there are as many straight runs as possible. Right now some wires have micro-misalignments that can be distracting.

I need to change the attributes on 106 of the same LED object in the schematic. One way is bulk selection logic that pulls up the inspector when objects are clicked on in the object panel. Another way that solves more problems is to bring the selector based workflow to schematic editor! After using it in the PCB editor, I just wish I could use its capabilities to edit the schematic too!

The list of options inside the Part Type Property isn't ordered in any discernible way. Please organize this alphabetically.