Auto-layout not respecting keepout
Nico
Steps to reproduce
- On an existing design add a selector rule that targets specific nets and sets a keepout (see the "Keepout" rule ) on the linked project
- Launch Auto-layout
- Check results
Expected results
- No nets should be routed within the keepout distance
Actual results
- In the attached project, at least one trace is.
- For example look at nets Net 3 and RJ12
Details
occurrence
: project to repro (required)
: https://www.flux.ai/nico/age-checker?editor=pcb_2dhow to access
: shared with supportregression
: No ideaNotes
- Fills are respecting this rule, but the auto-layout is not.