Bug Reports

Even though the PCB Editor shows there are no connectitions between the GND Stiching Vias and the 3V§ Power Plain (Inner 2) the Gerber Files do not. In the Gerber Files all Layers are Stiched Together leading to Short Circuits on my finished PCB

I'm working on this PCB layout and I got out of memory often https://www.flux.ai/support/customer-projectc-do-not-modify-2?editor=pcb_2d

When I clone a project, the Mid-layer 1 and mid-layer 2 layers in a PCB stack-up do not retain the name or layer type (plane) that was in the original project.

Can't get auto layout to route my board. Other users have also reported saying it has been happening since yesterday. when I click the cancel button I get an infinite spinner

Copper traces are not visible on the buttom layer. I can see pads in blue, components, drills, everything, but not traces, although these are selectable.

Some traces are missing from the bottom layer. There's a cutout in the fill, signaling that there are traces in there, and also those traces are visible on the gerber export. But they're not shown on the PCB editor. Project: https://www.flux.ai/nico/onboarding

If you select components on schematic and after switch to PCB tab(cross-selection) then Space Evenly will not work. You will need to unselect those components and select them again. https://www.loom.com/share/a7f8820f6d0a4ffd9057bd982a14d31b?sid=1693622d-ed99-4e18-8e6e-b5e440fb6b82

270mm x 62mm board 2 layers Min track width 0.8mm Max track width 1.5mm Kepout minimum 0.3mm SMD components + THD components Tried to perform auto route option as a test but it failed, no tracks are routed.